Hondata

Posted: **Mon Aug 17, 2015 1:45 pm**

HeHey guys just a quick question .. I'm about to send off my ecu to get upgraded from kpro v2 to v4.

Will the ecu be able to read and use the o2 reading from my AEM uego 30-4110 instead of the stock o2 sensor? (As in run the car in closed loop with the aem sensor for everyday use?)

My stock o2 sensor is buggered and I have a UEGO sensor at hand so I want to try use that instead. Is this feature now supported??

K20a swapped ek from Australia :)

Posted: **Mon Aug 17, 2015 3:16 pm**

Yes this is now supported. You must wire it into the analog input on the K-Pro board.

Posted: **Mon Aug 17, 2015 3:31 pm**

To be clear: this will work on the KPro4 but not the KPro2

Posted: **Tue Aug 18, 2015 8:22 am**

Thanks !! Posted the ecu off today . Hope it won't be too long before I can try it out .

Hondata

Kpro V2 with AEM UEGO everyday use?

Kpro V2 with AEM UEGO everyday use?

Re: Kpro V2 with AEM UEGO everyday use?

Re: Kpro V2 with AEM UEGO everyday use?

Re: Kpro V2 with AEM UEGO everyday use?