Page 1 of 1
lambda datalog tables not working
Posted: Thu May 21, 2015 4:16 pm
by muddauber351
Hi attached datalog and map.
the lambda datalog tables are not working
as well as the percent to reach target lambda.
the boxes are highlighted when I drive but there are not any values in the box
Thanks John
Re: lambda datalog tables not working
Posted: Thu May 21, 2015 4:27 pm
by Spunkster
What wideband are you using and what input on the ECU to you have it wired to?
Re: lambda datalog tables not working
Posted: Thu May 21, 2015 5:24 pm
by muddauber351
innovate l-c1 wideband and input on d14o2.
everything has been working for the last year until last night. Thanks John
Re: lambda datalog tables not working
Posted: Fri May 22, 2015 12:04 pm
by Spunkster
Check to make sure that all the settings are being met in Options, Settings, sensor overlay.
Re: lambda datalog tables not working
Posted: Fri May 22, 2015 1:56 pm
by muddauber351
How should they be set to make it work.
I have tried many combinations
In sensor overlay one lambda
and if I use sensor overlay 2 what sensor should I be using I have tried af with no luck
Also when I change sensor overlay do I have to cycle the car on and off
Thanks John
Re: lambda datalog tables not working
Posted: Fri May 22, 2015 3:15 pm
by Spunkster
Here are the settings used
Re: lambda datalog tables not working
Posted: Fri May 22, 2015 5:22 pm
by muddauber351
That is correct I have it set like in your pic. Thanks John