Page 1 of 1
k24a1/k20z3 vtec killer needed
Posted: Wed May 06, 2015 12:00 pm
by mhewitt
Stock bottom end k24a1 with a stock k20z3 head using crv rocker arms to run on high lobe all the time, looking for a calibration to get me going safe enough to drive 90 min to my tuner
Re: k24a1/k20z3 vtec killer needed
Posted: Wed Nov 18, 2015 9:37 pm
by mhewitt
any help from anyone? need a kal to get this car running good enough where i can make some fuel changes and drive it easy to my tuner
Re: k24a1/k20z3 vtec killer needed
Posted: Thu Nov 19, 2015 10:44 am
by Spunkster
You should talk to your tuner about this.
Re: k24a1/k20z3 vtec killer needed
Posted: Mon May 16, 2016 11:52 am
by mtxmatrixx
Anybody has a tune or base calibration for this setup?.. I also need one to get the car driving.