Hondata

No upload
No datalog
Download or opening of kal yes
Engine runs like limp mode. Takes longer to prime fuel pump like 8 seconds. Where it was less than 1 as soon turn key.
Mil stays on but can't get error code
Runs like sh@!.. No other source for ecu or vehicle to try on..
Version 3.2.4
No problems since purchased on 3 2010 Wtf.
Kpro # 8045 ecu # 37820-prb-A04. Serial # 2068-401178
K24 vtec killer Eg sparks harness k20a2 engine harness and charge as well..

Start by downloading the most recent version of software from the downloads section of the website.

Open the software, then go to the online menu and choose erase ECU. When that finishes, close the program and reopen it, then go to new calibration and choose on eht ecalibraitons there and try uploading it to the ECU. If that works then you should be able to upload your own calibration.

Ok will do thanks for the quick reply, i'll do this and keep you updated as soon i get home (@ work).

Yo mang thanks for the info that was it a simple update. Say if you have a chance can you tell me what you think of my old tune.
Like i said before k24a1 head single lobe killer k20a2 cams 50 vtc* limited to 30* on stock a4 pistons. a2 tb-rbc-plm header- modded injectors- 2.5 exhaust.