Hondata

I am having so much trouble with my flash pro.

1. when i first plug it into the computer it says the calibrations need to be updated to download and upload again.

2. when I do that the program either closes or has an access issue.

3. when i try to upload to the car itself from the ecu it says failure in step 3.

I checked the calibration on the flashpro and it shows the one i picked and uploaded, but when I goto program the car the light stays on for only about 5 seconds instead of the who process happening

so If anyone here at hondata could help Id love it.

It is locked to my car as wel

First, what version of FlashProManager are you using and what is the FlashPro serial number?

For #1, if uploading again does not work then I would suggest deleting the calibration from the FlashPro to remove the message. Make sure that you have the calibration on your laptop first.

After you try to upload use the 'send support information to Hondata' function and we'll look at it.

Update: We've replied to your emails.