engine runs fine but? wont start again,yet?
Posted: Mon Nov 24, 2014 5:23 pm
hey guy's!
b20vtec @ 2126cc/13comp 240cc injs.
car idles well round 13-14 A/F and fairly consistent through to 5700 (only tuning low cam fuel table ATM!).
the way i got my tables, the way they are was by mathematically increasing the % per kpa vacuum & by rpm point. from 59kpa/900rpm @ 128 m/s injector time.
but below the 900rpm to 500rpm i'm thinking my fuelling is not enough to crank the motor over?
but on a side note? when I press the throttle rapidly past 30% I'm getting hesitation. but when i ease the throttle down its fine? whats up with that?
oh & heres my calibration!
b20vtec @ 2126cc/13comp 240cc injs.
car idles well round 13-14 A/F and fairly consistent through to 5700 (only tuning low cam fuel table ATM!).
the way i got my tables, the way they are was by mathematically increasing the % per kpa vacuum & by rpm point. from 59kpa/900rpm @ 128 m/s injector time.
but below the 900rpm to 500rpm i'm thinking my fuelling is not enough to crank the motor over?
but on a side note? when I press the throttle rapidly past 30% I'm getting hesitation. but when i ease the throttle down its fine? whats up with that?
oh & heres my calibration!