hey guy's!
b20vtec @ 2126cc/13comp 240cc injs.
car idles well round 13-14 A/F and fairly consistent through to 5700 (only tuning low cam fuel table ATM!).
the way i got my tables, the way they are was by mathematically increasing the % per kpa vacuum & by rpm point. from 59kpa/900rpm @ 128 m/s injector time.
but below the 900rpm to 500rpm i'm thinking my fuelling is not enough to crank the motor over?
but on a side note? when I press the throttle rapidly past 30% I'm getting hesitation. but when i ease the throttle down its fine? whats up with that?
oh & heres my calibration!
engine runs fine but? wont start again,yet?
engine runs fine but? wont start again,yet?
You do not have the required permissions to view the files attached to this post.
Re: engine runs fine but? wont start again,yet?
ive swapped out the 240cc and placed in some 310cc injs adjusted the maps. and now starts first go cold even after it warmed up.