Hondata

Posted: **Thu Nov 13, 2014 8:25 am**

Is there a way to datalog the on/off engagement of methanol injection?

Currently, I have methanol injection to engage on an independent boost switch, but I want to incorporate it into Flashpro. Since there is no apparent feature to control methanol injection such as nitrous control in K-Pro, is there at least a way to monitor when methanol engages so I can view it in my graph?

Just a thought-- I'm already using the EGRL input for a wideband input. Are there any other inputs available?

Any ideas/suggestions are greatly appreciated.

Posted: **Thu Nov 13, 2014 11:10 am**

There really is no easy way of doing this as analog inputs are 0-5v and the injection kit will be 12v.

Posted: **Fri Nov 21, 2014 12:01 pm**

You could just switch to a manual boost controller and use your current boost control solenoid driver to run a MAP vs RPM ADI map. You would need support from Hondata to do so though, so good luck with that. lol

Hondata

Analog Input? How to datalog methanol injection engagement?

Analog Input? How to datalog methanol injection engagement?

Re: Analog Input? How to datalog methanol injection engageme

Re: Analog Input? How to datalog methanol injection engagement?