Hondata

I've been having an issue with flashpro manager for a while, where anytime I save a calibration after I am done datalogging/tuning a car and then close out of flashpro manager, I have an issue reopening the calibration, it always says "the file appears corrupt". Every time I want to datalog/tune a car with flashpro on it, I have to download the calibration on the flashpro to the computer and then datalog/tune it, and make sure I upload it back to the flashpro after my changes are done, or I'll never be able to open and upload the calibration again.

I have the latest version of 1.9.3, and I am using a generic display (because I was told a wrong display can corrupt the calibration)

Pictures below, I am not even connected to the flashpro and I cannot open calibration files. This is only an issue on Flashpro Manager, it isn't an issue at all on K-manager, S300 manager or my Cobb accessport manager.

Try downloading the most recent beta version of software from the downloads section of the website.

sorry for the late update. i forgot about this because i havent used flashpro in a while. most recent update is always in use. i update every time i get the prompt. issue still exhists, though.

From Help, About, what version of software are you actually using?