Page 1 of 1

Is this normal AFR for cold start?

Posted: Fri Oct 24, 2014 2:46 am
by munro88
Are these AFRs normal for a cold start?

Stock ITR base map for a STOCK ITR (aussie 11:1 CR) with I/H/E

Image

not sure why columns 7 and over have light up when i didnt take the car over 1600rpm, in my drive way (touched the throttle slightly)....

originally pulled codes 13 and 16 - so disabled fuel injector error and barometric pressure sensor. codes gone, will this effect the car's driveability ?

I am not using a wideband until the dyno so it is reading off stock o2 sensor.

Re: Is this normal AFR for cold start?

Posted: Fri Oct 24, 2014 9:24 am
by Spunkster
Ignore those readings since you do not have a wideband, they are not going to give you any real data.

If your ECU does not have the circuitry for those things then you must disable the errors.

Re: Is this normal AFR for cold start?

Posted: Fri Oct 24, 2014 3:35 pm
by munro88
Thanks for reply. Is it safe to drive to see that no more codes come up?

Re: Is this normal AFR for cold start?

Posted: Fri Oct 24, 2014 3:41 pm
by Spunkster
That I could not tell you since there is no way to see the actual AF ratio.