Hondata

Folks, having an issue viewing Lambda Values and Fuel Adjustment Values in KManager v3.3.1.0. I'm using a the built in wideband as my AEM is not wired to the ECU. I can datalog, upload maps etc however no data is being populated in the specified tables (see image below). I can see the points moving around on the table when I hit the gas, but for some reason it's not showing any data.

The car is a JDM DC5 Type R, using a K-Pro v2. Also I set the minimum TPS value to 0% instead of default 4%, but that didn't work either. I've uploaded a .kal file with the tweaked basemap that I'm using for now.

Any help would be greatly appreciated. Thanks.

When was the last time you rebooted your laptop?

Spunkster wrote:When was the last time you rebooted your laptop?

Yesterday before I took the snapshot there. It's shut down and booted up everyday.

What are all your settings for lambda overlay?

This is it below:

Wideband input is as seen:

try 1% instead of 0%

Spunkster wrote:try 1% instead of 0%

Ok will try that, it was initially on 4% by default I think, I changed it to 0%.

Ok solved it. Just needed to drop down the cam angle thing and change it from 0 degrees to 10..20 etc. Then it showed data.

dev_typeR wrote:Ok solved it. Just needed to drop down the cam angle thing and change it from 0 degrees to 10..20 etc. Then it showed data.

What do you mean by that? Im having same problems.
When ill record datalog F9 afr is recorded normally to the graph but its showing only couple of afr values on the table.
It doesnt matter if cam angle is locked or changing.

If cam angle is locked then it should be in the same cam angle. Right?

It usually show low cam afrs but on high cam only 1 value on cam 20 and 1 value on cam 10.
Nothing in cam 40.
In last picture afr is green line in lowest box so its recorder normally to graph.

Could this be because of vtc solenoid. It got mad couple of times and and didnt hold steady cam angle.
Was bouncing from 15 to 25 on locked 20.

There was some bug in that kmanager version 4. I installed version 3. something and its working normal.

I do not believe that there is a bug, and in any case you should never downgrade versions. Can you post or email the datalog and calibration which shows the problem?

Having the same issue as ive checked so many forums…its showing its reading A/F on sensors page but not populating the fuel tables its does highlight where the current conditions are but doesn’t populate and doesnt matter cam angle or logging or anything and i never changed anything that mentioned not too….so is my issue i just need to get a wideband aem cause the built in using the wideband o2 isnt good enough once its running smooth? Or is there a setting im missing when ive checked everywhere…ive rebooted constantly making sure on kpro is going so no bogs to my computer and it all response just doesnt populate fuel tables so i can finally get my EK out the garage

Post the calibration and a datalog showing the issue.