Hondata

How do we tell when loading them up in Flashpro?

Look in the fuel section of the calibration window.

see fuel table type: http://www.hondata.com/help/flashpro/fu ... %2Bdensity

Spunkster wrote:Look in the fuel section of the calibration window.

see fuel table type: http://www.hondata.com/help/flashpro/fu ... %2Bdensity

Looked all over Flashpro and don't see where you can see "Fuel table type" check box as indicated in your link.

Diversion wrote:

Spunkster wrote:Look in the fuel section of the calibration window.

see fuel table type: http://www.hondata.com/help/flashpro/fu ... %2Bdensity

Looked all over Flashpro and don't see where you can see "Fuel table type" check box as indicated in your link.

Then it is probably a MAP calibration. Under the "Fuel" parameters do you see "Fuel low" and "Fuel high" listed? If so, it is using MAP for fueling. The AFM calibrations do not use these tables.

Yes there's a fuel high and fuel low parameters on this tune.. It's a stock based tune and I flashed yet I still have rev hang.. And i'm hearing no matter the tune, if it's MAP based it automatically removes rev hang.