Page 1 of 1
Help, failure ECU pin B2. I have no signal.
Posted: Fri Aug 22, 2014 12:42 pm
by roma
I need your support. I'm from Mexico and I have a 08 Civic SI turbo. I had problems with my boost control solenoid, it was damaged and then replaced. The deal is I'm not getting signal from the ECU (pin B2). Any suggestions? is a good idea to send the ECU to be repaired with Hondata?
Thank you very much for your help.
-Roma.
Re: Help, failure ECU pin B2. I have no signal.
Posted: Fri Aug 22, 2014 1:15 pm
by Spunkster
If the output on the ECU has been damaged then you will need to return your ECU to stock and unlock the FlashPro and get a new ECU and then lock the FlashPro to the new ECU. We cannot repair damaged ECUs.
Re: Help, failure ECU pin B2. I have no signal.
Posted: Fri Aug 22, 2014 3:31 pm
by roma
Spunkster wrote:If the output on the ECU has been damaged then you will need to return your ECU to stock and unlock the FlashPro and get a new ECU and then lock the FlashPro to the new ECU. We cannot repair damaged ECUs.
Ok. Bad news :( so, when I get a new ECU I'll need new keys too?
Re: Help, failure ECU pin B2. I have no signal.
Posted: Fri Aug 22, 2014 4:59 pm
by Spunkster
The HOnda dealer will also have to match your keys and immobilizer to the new ECU. They should know what to do.
Re: Help, failure ECU pin B2. I have no signal.
Posted: Fri Aug 22, 2014 7:27 pm
by roma
Ok thank you very much for your support (Y). One more thing, you know who could sell an ECU in good condition?
Re: Help, failure ECU pin B2. I have no signal.
Posted: Sat Aug 23, 2014 11:24 am
by roma
If I install a new ECU, the millage that was deleted? Because I had very little (19,000 mi). Thank you very much, I really appreciate your support.
-Roma.
Re: Help, failure ECU pin B2. I have no signal.
Posted: Mon Aug 25, 2014 9:33 am
by Spunkster
The ECU has nothing to do with the odometer reading.