Hondata

Im trying to lock my cam angles to tune 0,10,20,30,40,50 degrees maps. I go into my cam angle map and set all my values to 0 to lock it in. When I upload the map it completely locks my cam angle into 0 degree (which is what I want). But then now when I try to switch to 10 degrees cam angle to tune the 10 degree it wont let me? the drop down menu wont let me change my degrees to lets say 10,20,30,40,50. it stays locked at 0 even when I change my cam angle maps values to 10 degrees.

Am I doing something wrong here?

any help will do thanks.

Have you uploaded the calibration after making the changes?

Yes I have uploaded the changes. After I upload the changes I'm not allowed to change my cam angles to let's say 10.

Can you post the calibration? It could be that you have iVTEC disabled.