Page 1 of 1
Help with initial setup for modified vtec engine.
Posted: Sat Jul 19, 2014 6:58 pm
by hknobel
How do I set the S300 so that the vtec is actuated at 6000 rpm and stays on until redline. This is a highly modified frankenstein engine in an SCCA D modified Solo2 car.
Harold Knobel
Re: Help with initial setup for modified vtec engine.
Posted: Mon Jul 21, 2014 9:36 am
by Spunkster
Disabling VTEC window does not mean disabling VTEC. IT means that the VTEC will activate at the same RPM no matter what.
Re: Help with initial setup for modified vtec engine.
Posted: Mon Jul 21, 2014 1:35 pm
by hknobel
OK, thanks. The info about the s300 certainly does not read that way. It says setting the high and low the same disable vtec.
Harold