Page 1 of 1
Status of S300j v3
Posted: Tue Jun 17, 2014 6:33 pm
by shiroitenshi
Is the s300j v3 already available?
Also, is there more details on the CAN output? Can we wire it to a OBD2 DLC connector?
Re: Status of S300j v3
Posted: Wed Jun 18, 2014 2:15 am
by excaliburcombo
if not mistaken already available. heard KL already start selling.
Re: Status of S300j v3
Posted: Wed Jun 18, 2014 7:15 am
by Hondata
S300J V3 has been available for about 4 weeks.
The CAN output is not suitable for OBDII. It was designed to drive a dash or datalogger.
Re: Status of S300j v3
Posted: Sun Jul 06, 2014 7:00 pm
by Razzie92
is it compatible with OBD0/OBD1 JDM ecu?
Re: Status of S300j v3
Posted: Mon Jul 07, 2014 7:55 am
by Hondata
Yes, the JDM OBDI P08, P30 & P72 uses the s300J
Re: Status of S300j v3
Posted: Mon Jul 07, 2014 6:14 pm
by Razzie92
Hondata wrote:Yes, the JDM OBDI P08, P30 & P72 uses the s300J
sorry bout my previous question, the s300 v3 can be install to JDM ecu?
Re: Status of S300j v3
Posted: Tue Jul 08, 2014 9:03 am
by Hondata
Yes, using the S300J (which is v3)
Re: Status of S300j v3
Posted: Wed Jul 09, 2014 6:44 pm
by Razzie92
Hondata wrote:Yes, using the S300J (which is v3)
thanx for the fast reply