Hondata

Hi guys!

Some urgent help please!
I installed Version 1.8.1.0 Firmware 63 on my Flashpro and while trying to use it ,it powered off by itself after some seconds.
On Monday I saw the new update and (Firmware 64) that should solve this problem,and so it did.
My main problem that being a race car,I raced on Sunday with Firmware 63 and It sent my car in safe/limp mode.
Could it be Ver.1.8.1.0 of switching off the Flashpro cause the car to go on limp mode while driving?
We are somewhat blind as Flashpro was not datalogging anything at all!

Race track is not available to test until another race is scheduled!

The problem affected uploading and datalogging, but not the calibration which was uploaded.

Tks for the quick reply.
We had just tested the car the weekend before the races and it was perfect.only uploaded the new version before the races.
That was the only thing we changed , so it should be some other error/fault then.
Thank you

Hi, with ref to my previous problem, could it be that the engine went into an over rev condition ie about 9750rpm during engine braking and thats when the "limb mode" came active?

Check for error codes. 9750 rpm on a AP2 engine probably is not good, so it could be mechanical.

The engine is European F20c (AP1).No error codes as datalog was not functioning due to new version of Flashpro as previously said. Is it normal to go on limp mode due to engine brake overrev?