Hondata

Hi,
I would like to know if my flashpro that i have on my 2012 civic SI will be compatible with the 2014 civic SI. I suppose i will have to wait for a update and if so, i would like to know if you have any plan to release an update soon.

Thank's.

What is the ECU part#?

Spunkster wrote:What is the ECU part#?

I will have the car next week, so i will be able to send the ECU part# only at this time. Sorry.

The # is 37820-RX0-A21

This is not yet supported, but we are looking into it.

Spunkster wrote:This is not yet supported, but we are looking into it.

Ok, thank's.

@ Hondata, any news yet? I was about to start a thread asking, and seen this one. I too have an 2014 Si. Have to guys compared the stock ECU programs 2012 and 2013 to 2014 to see if there's any difference? I ask because I know there's a horse power and torque increase and there maybe sight changes Honda has done to the programing to accommodate the hardware changes.

It's a couple of months away.

Hondata wrote:It's a couple of months away.

How do you guys keep on top of each "new" build. Does Hondata go out and buy the car for R&D or do you pick willing ppl that bought the car?

Also here's my Canadian 2014 Si ECU # 37820-RX0-A21 which is the same.

It may be helpful to merge this discussion with the similar one under the "Applications" thread:
http://www.hondata.com/forum/viewtopic.php?f=10&t=17328

Im also having an issue u say I can use 2012 cals on my 2014 si right but I keep gettin an error saying u cannot use a calibration ment for a 2012 flashpro on a 2014 flashpro wats the issue here it wont let me load my supercharger basemap ive got both a 2012 map and a 2013 and both give me the same error message because im assuming they werent created using a 2014 flashpro or at least when they selected the vehicle they dint select 2014

Post the calibration you are having difficulty with

here is the calibration that wont load onto my flash pro...all the preloaded ones will

Make sure you have everything plugged in and the key in the on position when you do this. We have tested this calibration and it works as it is supposed to with a 2014.

From Help, About, what version of software are you using?

The new 1.9 watever I updated it when I got it here is wat I get when trying to load it