Hondata

Posted: **Sun Apr 13, 2014 11:45 am**

Hey guys!

Have a AFR issue with my s300. I have the AEM uego connected to D10 and resistor cut in the ECU. Still the s300 wont read lower then 12.1 but the gauge shows 10-11. Any ideas how to fix this?

Posted: **Mon Apr 14, 2014 11:03 am**

HAve you checked the voltage on the output from the AEM using a multimeter?

Posted: **Wed Apr 23, 2014 3:29 am**

you removed both resistors, or just one?
where do you connected the wideband +V and ground?
how long are the wires?

(lower than 12.1 is arround 1.20V)

Hondata

AFR issue D10 ELD

AFR issue D10 ELD

Re: AFR issue D10 ELD

Re: AFR issue D10 ELD