Hondata

-S300 V2 serial number 20894
-ECU P28
-Honda Civic 3 doors 1992 D16Z6 NA
-Std air filter, Skunk2 intake manifold, Skunk2 TB ,Hondata intake man gasket,Standard Injectors (240cc), AEM Uego wideband O2

Software SManager 2.2.7
When i was doing data logging, after the table switched to 2nd table (high speed fuel table) or when i reached VTEC point, there's no afr's data on table cells , only highlight on cell. But in first table (low speed fuel table) it could log the afr's data. Re-boot the laptop didnt work as well. I've downloaded the new updated software 2.3.0 but the problem still there.

Regards

Under Options, settings, sensor overlay, what settings to you have. It appeasrs to be working normally with the datalog and calibration you have sent.

when switch to high speed fuel table it goes blank, no afr can be recorded, can you see it at my datalog that i posted.

thanks for reply spunkster

Change your max throttle to 120%

Solved, thank you so much Spunkster.