Hondata

V2.3.0 (14 Mar 2014)

• Added support for the S300 V3.
  Added Flex Fuel ignition compensation.
  [S300 V3] Added Flex Fuel direct sensor digital input.
  [S300 V3] Added AiM dash and RacePak dash outputs.
  [S300 V3] Bluetooth communication.
  [S300 V3] Advanced engine protection.

V2.3.1 (15 Apr 2014)

• [S300 V2] Fixed calibration download.

V2.3.2 (18 Apr 2014)

• [S300 V3] Fixed analog input on board datalogging.

V2.3.3 (14 May 2014)

• [S300 V3] Fixed flashing red light upon power on.

1) Does S300 V3 have an exportable datalog for Knock?

2) If exportable via DDE, can you provide guidance/links as to how this would be done?

1. No. The knock on the OBDI ECU is mostly handled by the knock board, so you only get to see the retard anyhow.
2. Yes. See the help http://www.hondata.com/help/smanager/dde_server.htm and the example code in google code.

Thanks. Any recommended tools/links to write a CSV file (that can be imported to excel) from DDE?

Does the new software work with v2?

9queSt wrote:Does the new software work with v2?

Yes.

Any plans to allow digital inputs to be used for the advanced protection??

No plans, but I'll look to see if it is possible.

How do we get a CSV file for the all the DDE Server data (like when we use the Datalog>Export in the "Graph" window)?

Hondata wrote:No plans, but I'll look to see if it is possible.

That would be awesome -- I have been looking at converting to all the PLX goodies using the digital feed.


Also -- a boost control adder like the ignition/fuel tables for flex fuel would be awesome. It would be fun to flex fuel the DC2, but no point til I can turn the boost up with ethanol content...

I would rather have manual control of the boost (via the current high/low boost control) than letting the ECU device how much power to make. Ignition & fuel adjustments yes, but the idea of the power level changing day to day would be dangerous in some situations.

"Shift+F1" button to go to normal table doesn't work, it goes to Hondata Guide page (SManager Help Contents). it didn't happen on prev software version and i didn't change any keyboard shortcuts as well.

This has been fixed for the next release.

Going through a datalog that I recorded while linked via bluetooth... as I move the cursor position, none of the values in the 'Sensors' window update....

Works for me. Was it a laptop datalog or an on-board datalog?