k pro error code P0600

[SERDC5]

i have a base auto 02 i did my rbc swap runs fine but i need to get k pro installed
i load the base map then when i hit the thunder bolt it gives me this code P0600.
which is the multiplex is not present for engine swaps i have a stock motor just bolt ons and rbc.
i was reading on club rsx that people switch their multiplex aka fuse box under the dash that people swapped them out but their 300 at
acura ! how can i go about this?
this is holding me back from driving my car which is my daily

[Spunkster]

I'm sorry, but the K-Pro does not support automatics.