Hondata

Hello, I received my K-Pro today and I look at how to setup it on my S2000 2001.

I would like to using a manual switch for start and stop my datalogging but I do not understand how.

In K-Pro software, it gives pin to connect a switch but are those of a RSX ecu.

Someone could help me by giving the equivalent of a s2000 ecu. I do not want to break something...


Thanks

The S2000 pins are listed in the help file.

http://www.hondata.com/help/kmanager/ecuconnectors.htm

eg E16 PSP (RSX) = A26 (S2000)

Ok, Thanks.

If I connect the switch for start and stop datalog on PSP, I have to cut the wire that goes into ecu A26.

Wire on pin A26:
Switch open = datalogging on
Switch to ground = datalogging off

And the ecu will not have the PSP signal, its will not disturb?

nobody can answer?

Usually it is best to remove the pin from the ECU plug (and insulate it). That way you can always return it to stock without cutting / joining wires.

Then A26 should be wired to ground via a switch.