Noob needs help with Sensors/CEL

[InTheZone]

A shop put a basemap on my s300 v2, car runs, idle sucks and I try not to get boost at any point. It lets me drive home and back to the shop when I'm ready for a tune.

I need help with reading sensors and checking a CEL that I now have.

I start the car, hook up the ecu to laptop, open smanager, read codes and blank. But I have a CEL light. I can clear DTCs, code goes away then comes back about 20 seconds later. I try to read codes again and it's blank.

If I try to read any sensors, the list showing RPM, MAP, IAT, TPS, etc. it shows zero for everything. When I go to the info screen everything checks good when it checks for smanager ecu and firmware.

This is my first time using this program on my laptop, it's already registered, what am I missing?

[Spunkster]

Are you datalogging when you are looking at the error codes?

[InTheZone]

No, but I'll look for that next time