How can I convert the Wideband into a readable format
Posted: Wed Jan 22, 2014 8:34 pm
So I have my Wideband setup and wired into D10, I made sure my conversion is on too.
What im trying to do is set something up in the "display" so I can see if im lean or rich. All its letting me do is show the volts. (I made a "value" for ELD and lambda voltage. And they both display the same voltage)
I have volt input in parameters, closed loop advanced set to what the gage calls for. Thanks!
S300 V1 on 2.2.7.0
What im trying to do is set something up in the "display" so I can see if im lean or rich. All its letting me do is show the volts. (I made a "value" for ELD and lambda voltage. And they both display the same voltage)
I have volt input in parameters, closed loop advanced set to what the gage calls for. Thanks!
S300 V1 on 2.2.7.0