issue with the cpr and s300.....
Posted: Mon Nov 18, 2013 8:37 am
Ok....I have s300 on p28. I switched to cop and ran everthing to spec. I go to start car and it just turns over. No sync light.
So from there I tried a 2 friends ecu's with s300 and sync light came on and fired the car right up. So I then put one of my buddies s300 board in my ecu and sync light came on and fired up. So I then put my s300 in his ecu and no sync light and no start. So I put everything back (my ecu with my s300) and tried again. No sync no start.
I then put my ecu with my s300 in another buddies car who is running just factory ignition, and it fired his car up. Just like it did with mine before I installed cop.
I'm not sure what to try now....any suggestions?
So from there I tried a 2 friends ecu's with s300 and sync light came on and fired the car right up. So I then put one of my buddies s300 board in my ecu and sync light came on and fired up. So I then put my s300 in his ecu and no sync light and no start. So I put everything back (my ecu with my s300) and tried again. No sync no start.
I then put my ecu with my s300 in another buddies car who is running just factory ignition, and it fired his car up. Just like it did with mine before I installed cop.
I'm not sure what to try now....any suggestions?