Hondata

Hello,
I have a B18C rebuilded with darton sleeve at 84mm bore
CP pistons 12.0:1 CR, Manley rods, stock gsr crank with API damper
the head have a polish and porting job fron King motorsport,
ferrea oversize valves with JUN spring, retainers and stage 3 cams
the headers are skunk 4-1, the intake manifold, trotle bodi 68mm and V2 aem cold air pipe
transmision, 4.7 Final drive
fuel system walbro 250 lpm pump, aem fuel rail, 440cc RC injectors and fuel [ressure regulator

Can you please help me with a base map for this set up,

Thanks in advance for your help

Hey,

intressting setup i wrote you a PM about tuning the Setup

Regards Aaron

AaronEG wrote:Hey,

intressting setup i wrote you a PM about tuning the Setup

Regards Aaron

Hey guys this is the closest thing to my setup Ive seen on here Aaron can you send me that PM please I need to drive my car to the tuner which is about 40 miles from where I live and I need a basemap for my s300v2.

my setup is something similar to this i was wondering if u could send me the base map if possible so i can get my car started after a long build of over 4 years. thanks