s300 v2 not changing settings.
Posted: Fri Nov 08, 2013 3:16 am
Hi just got my s300 back from dealer after a few teething problems.
Ecu and s300 was working 200% when I left. There was a itr base load and started and run my eg fine.
The problem is this. . If I change for example the rev limit from 8700 to 7000 or 9000 load it to the ecu nothing happens but if I download from ecu the setting have been changed
I tried this with vtec and launch control to confirm and got the same result.
Datalog is working car running 12.7 air fuel
Using an ntk wideband and hondata 4 bar map
Stock b18c type R engine ukdm p30
windows vista as computer.
Any ideas ??
Ecu and s300 was working 200% when I left. There was a itr base load and started and run my eg fine.
The problem is this. . If I change for example the rev limit from 8700 to 7000 or 9000 load it to the ecu nothing happens but if I download from ecu the setting have been changed
I tried this with vtec and launch control to confirm and got the same result.
Datalog is working car running 12.7 air fuel
Using an ntk wideband and hondata 4 bar map
Stock b18c type R engine ukdm p30
windows vista as computer.
Any ideas ??