Hondata

Hi yall,

The rsx type s comes stock with launch control at 4500 rpm. Same for the tsx.

Juste wondering if someone know the stock launch control setting for the rsx type s.

Ps : stock rsx type s 2002-2004 cal in k-manager does not come with the launch control activated but the stock rsx type s ECU comes with launch control activated.

Thanks.

A stock RSX does not have launch control. It just has a 5000 RPM rev limit when the vehicle is not moving.

Then, can I put launch control ? And wath setting should be the best ?

This is adjustable as what will work well for one person may not work for another. You will have to experiment and see what works best for you.

If I set the launch RPM limiter to 3000 rpm, then the Fuel & Ignition retard activation RPM should be below like 2800 rpm or 2600 rpm ?

ps : the settings already written when I activate the launch control does not make sense

If you are NA, then you should not need to have any fuel or ignition changes for a launch limiter.

Then I don't change anything ? Just enable it and try it like that ?

Ps : I don't know wath is NA !

naturally aspirated

It does not work. I just activated it with stock settings but it does not work.

Post your calibration and a datalog showing it not working.

I think that my datalog file is to big to post it on the forum (about 19mb) but here is my .kal

You can trim the datalog down, or make a shorter datalog. We need to see the datalog.