Hondata

K-Pro S/N = 124, Yes, it's that old. However, earlier this year I sent it in to update it with on board memory.
ECU part number = 37820-PRB-A03, S/N = 2068-201559, KManager version 3.2.5.0, K20A2 installed in a Lotus 7.

I installed an Innovate MTX-L wideband, connected yellow wire to ELD and enabled it in kal and set up KManager settings per help file. The Display shows the air/fuel numbers and the Graph shows the ELD.V correctly. When I export the data log the help file indicates the A/F number should be in the Lambda column. "lambda - air/fuel ratio (lambda)".

However, as seen in the attached data log, my Lambda column starts out at 1, goes to .73 and stays there. It doesn't correspond to the TPS and ELD.V data changes. Is there any way to get the A/F number that shows up in the KManager Display into the data log export file?

Thanks,
Jeff

Revisiting this. I seem to get valid A/F data on the K-Pro dashboard but I'm having trouble getting valid data in either my lambda, ELD or ELD.V columns when I export a K-Pro data log and bring it into Excel. See the attached .csv file. Do others get valid data in these columns?