Hondata

i have a 95 Honda civic with A B20V had the s300 installed professionally. And here is where I am at I have uploaded 2 diff base maps both are running in limp mode no revs above 4000 rpms. when I am connected to the laptop it says online and will read the calibrations and sometimes I can make changes sometimes I cant. the d4 light is green. also have the boost option installed in the ecm. I made sure the s300 is properly seated in the sockets. and the ecm frame has been altered to insure proper seating. any help or advise would be greatly appreciated.

Check light off after key on?

Post a picture of the s300 installed in the ECU. Also post a picture of the soldering on the bottom of the ECU. Has J12 been cut?

I will get another pic of the bottom so you can see the solder joints. I have taken the ECM back to the shop which installed it. He proceeded to tell me that he switched out my ECM with a virgin p28 which it wasn't it is a 1702 non vtec ECM. So at this point I have further issues. He says that because my ECM was already chipped I couldn't use it but just the socket had to be changed to accept the s300. Because it was a female socket. I am pretty furious right now to say the least. I also removed the s300 and started the car and still had cel with no codes.

I just looked at another pic of the top and the j12 has been removed.

today I took my s300 and installed in another ecm that already has an s300 socket and I had the same outcome. solid cel as soon as the vehicle was started and it wasn't my vehicle. so that ruled out my car being an issue. I did contact hondata tech support today and performed an ecu erase and shut my program down on my laptop reopened the program uploaded a new calibration and I still have the same outcome.

Send and email to support <at> hondata.com with the following and I will issue an RMA and give you further
instructions (include a link to this thread):

Name:
Address:
Phone:
Email:
Serial#:
Description of problem:

hey spunkster just wanted to let you know I spoke with carlos at hondata and he issued a rma number to send it in. thanks for your help and concern