Page 1 of 1
AF display not going below 12 or above 19
Posted: Thu Jun 27, 2013 10:20 pm
by DOHCAccord
Hello,
while datalogging my s300 display will not read below 12 or above 19 for AF.
My wideband will go to as low as 10 before showing rich and 20 before showing lean...
The wideband is accurate but the display will not show the higher or lower numbers...
any ideas on this?
Re: AF display not going below 12 or above 19
Posted: Fri Jun 28, 2013 9:22 am
by Spunkster
You need to provide much more information such as what wideband you are using, what input you are using on the s300 and exactly how you have it all wired.
Re: AF display not going below 12 or above 19
Posted: Mon Jul 01, 2013 5:10 pm
by DOHCAccord
the wideband is the PLX m-300 and is wired into the ecu via the D10 input
Re: AF display not going below 12 or above 19
Posted: Tue Jul 02, 2013 9:12 am
by Spunkster
Have you removed the resistors as it says in the help file?
http://www.hondata.com/help/smanager/wi ... ub=eld+d10
Re: AF display not going below 12 or above 19
Posted: Thu Jul 04, 2013 6:05 pm
by DOHCAccord
i opened the case and the resistors are in place.. how do you recommend removing them from the ecu?
Re: AF display not going below 12 or above 19
Posted: Fri Jul 05, 2013 9:52 am
by Luke
DOHCAccord wrote:i opened the case and the resistors are in place.. how do you recommend removing them from the ecu?
solder them out. easy as that.
Re: AF display not going below 12 or above 19
Posted: Mon Jul 08, 2013 9:49 am
by Spunkster
Or cut them out with a wire cutter.