Hondata

Hi
i bought a little used V1 s300 from a friend and it was working when he was using it a year ago or so. but i plug it in my car and my tuner tried tuning the car on it but it was impossible to get the car running on the ecu and smanager wasn't showing any sensor data.

also there was a red light on the s300 board
what could be wrong?

- serial number is S300-12766
- 99 Civic Si
- P28
- Turbo, RC 1200cc injectors, Xenocron 3bar map sensor, Mac Boost solenoid,

with best regards
Arni

From Help, About, what version of software are you using?

my tuner is using 2.2.4

Start by downloading the most recent beta version from the downloads section of the website and see if that resolves the issue.

i downloaded the newest beta version and nothing changed so i googled some of the problems and one said to erase the ecu but after waiting for 20minutes for that to finish i got the message ecu did not erase so i tryed again and got the same message but this time i was using a stock b16 car and i started and ran the b16 basemap but no sensor data, i can upload changes to the ecu but it takes time to do so

what could be the problem?


Report this post

Send an email to support <at> hondata.com with the following and I will issue an RMA and give you further
instructions (include a link to this thread):

Name:
Address:
Phone:
Email:
Serial#:
Description of problem: