Hondata

Here is my set up:


OK, so kinda new here. this is the mods I have on my current set up
gsr bottom end:
ls crank
eagle ls rods
81.50 pr3 pistons
Race balance on whole rotating assembly
stock 3 layer head gasket

B16a2 head:
blox springs and ti retainers
Blox type C cams
stock valves, new valve guides
itr Intake
omni 68 mm tb
stock gsr injectors
short ram with blox velocity stack

gsr tranny:
exedy stage 1 clutch
exedy 9.5 lb flywheel

also here is my a/f data log from Logworks, since I cant get my hondata to read my MTX-1 its on dropbox, so it has all the info.
https://www.dropbox.com/s/nduhyx5ijep95 ... 051913.skl
https://www.dropbox.com/s/solzu1nj622gk ... arpull.s3d
https://www.dropbox.com/s/mfh72zpfmu5xc ... arpull.log

You need to upgrade your injectors and fuel pump. You need to get TUNED. I think you running close to 12.5:1 with those pistons.

Yea need to upgrade injectors and fuel pump according to you datalog you maxing them out at 5800 rpm. So you have another 3k to go. Upgrade and get it tuned.

Progress wrote:Yea need to upgrade injectors and fuel pump according to you datalog you maxing them out at 5800 rpm. So you have another 3k to go. Upgrade and get it tuned.

I was told at machine shop I would be at 11:6:1
So up grade fuel pump and injectors. so prob rdx injectors will do? I uploaded another data log with my wide band working with hondata, just want to double check. Thannk you for your help.

Use RC 440cc. No you around 12.3:1-12.5:1.

I'll check your log tomorrow, im going to bed now.

Last log is blank. Didnt record.

Sorry about that. Here you go. Let me know if this looks right.

TunerFreak89 wrote:

jdragon1974 wrote:

firsttunewithcams051913.skl

3rdgearpull.s3d

Here is my set up:


OK, so kinda new here. this is the mods I have on my current set up
gsr bottom end:
ls crank
eagle ls rods
81.50 pr3 pistons
Race balance on whole rotating assembly
stock 3 layer head gasket

B16a2 head:
blox springs and ti retainers
Blox type C cams
stock valves, new valve guides
itr Intake
omni 68 mm tb
stock gsr injectors
short ram with blox velocity stack

gsr tranny:
exedy stage 1 clutch
exedy 9.5 lb flywheel

also here is my a/f data log from Logworks, since I cant get my hondata to read my MTX-1 its on dropbox, so it has all the info.
https://www.dropbox.com/s/nduhyx5ijep95 ... 051913.skl
https://www.dropbox.com/s/solzu1nj622gk ... arpull.s3d
https://www.dropbox.com/s/mfh72zpfmu5xc ... arpull.log

I couldn't figure how You where unloading in 1st in ALL Blue. Then, I noticed your 1st gear ratio 3.20's, nice figures sir. Great build.

Thanks, still trying to figure how it is 12:3 or 12:5 or what ever was said, could have sworn i was at 11:6:1, but I guess it would explain alot, 93 oct is the best gas I can get, would not mind going e85 if there was more places that had it.