Page 1 of 1
Another wideband/flashpro question.
Posted: Sat May 18, 2013 1:56 am
by vadik_s2k
So the car is 2006 USDM S2000, I have AEM wideband connected to ELD but my tuner says this input cannot read A/F values below 12-12.2..is this true? We don't have a choice of inputs in s2000, only ELD and ECT2?
Also I'm using offset and I heard it's not gonna be accurate to datalog wideband with offset? Should I re-ground wideband to the ECU ground?
Thank you!
Re: Another wideband/flashpro question.
Posted: Mon May 20, 2013 11:44 am
by Spunkster
Do you actually have it installed yet and have you verified that it is not reading the full voltage?
Re: Another wideband/flashpro question.
Posted: Thu Jul 04, 2013 2:57 pm
by vadik_s2k
yes, it is actually doesn't read anything beloq 12.14:1, just like the stock sensor doesn't read lower than 10.14:1 in the flashpro logs..
Re: Another wideband/flashpro question.
Posted: Mon Jul 08, 2013 4:48 pm
by Spunkster
Can you post your calibration as well as a datalog showing the problem.
Re: Another wideband/flashpro question.
Posted: Wed Sep 24, 2014 3:17 pm
by ek9max
Did this ever get resolved? Mine isn't reading below 11.7. My gauge is reading 10 flat though.
Re: Another wideband/flashpro question.
Posted: Fri Nov 28, 2014 12:58 pm
by antkouv
Same issue here. With a PLX device it only reads down to 11.7. Datalog attached.
The PLX gauge shows correct values (for example 10.8-11.5)