Page 1 of 1
S300J Boost output
Posted: Wed May 08, 2013 4:02 pm
by crixzc
Has anyone used a P72 IAB output to control boost solenoid, I see that it has recently been added as a feature. I have tried to use this feature on other platforms with not much success. Any advice how to set this up, other than clicking enable boost and he variable frequency box?
Re: S300J Boost output
Posted: Wed May 08, 2013 4:23 pm
by Spunkster
Are you using rectangular or square case ECU?
Re: S300J Boost output
Posted: Wed May 08, 2013 6:03 pm
by crixzc
Square, I have the correct version of hondata (S300J V2) and small square JDM ecu with the +12V output. I understand how to complete the hardware portion of the installation, I do not understand how to configure and adjust the software portions (SManager).
Thank you for your speedy responce
Re: S300J Boost output
Posted: Thu May 09, 2013 9:10 am
by Spunkster