Hondata

OK, so kinda new here. this is the mods I have on my current set up
gsr bottom end:
ls crank
eagle ls rods
81.50 pr3 pistons
Race balance on whole rotating assembly
stock 3 layer head gasket

B16a2 head:
blox springs and ti retainers
stock valves, new valve guides
itr Intake
omni 68 mm tb
stock gsr injectors
short ram with blox velocity stack

gsr tranny:
exedy stage 1 clutch
exedy 9.5 lb flywheel

Running hondata s300, looking for a good base map als is it bad to run stock cams on the blox springs and retainers, waiting on getting paid to get some blox type c cams. Thank you.

You can use a type r basemap so you can get to the tuner.
And you do wanna balance cams with springs

ok, so got my blox type c cams and it idles real good, but it bogs bad when I hit vtec.

Now take it to get it tuned

so I have added my logworks3 from my MTX-l wideband software, since I cant get it to work on hondata, a 3rd gear pull
so I have attached the hondata skl and the logworks datalog to see if I can get some help on this base tune.

If you have drop box, here is everything for my 3rd gear pull.
https://www.dropbox.com/s/nduhyx5ijep95 ... 051913.skl
https://www.dropbox.com/s/solzu1nj622gk ... arpull.s3d
https://www.dropbox.com/s/mfh72zpfmu5xc ... arpull.log