Hondata

Hi, how are you guys? I'm looking for base calibrations for a stock D16Z6 turbo build, this are the details:

- Stock internals
- Stock compression
- RC Fuel Injectors 440cc (high impedance)
- 255 lph walbro fuel pump
- 3 bar map sensor
- 7-8 psi on the turbo (it will depend on the base calibrations that I get here)

Someone have a file to download??
If you could help me I would be grateful, thanks!!

I just got my d16z6 dyno tuned. stock internals, RC 440's. What turbo are you using. I'm using a dsm 2nd gen t25. I can share my tune with you if you'd like since there's a lack of d16 turbo tunes on this forum

Hi, thank you for your answer! I'm thinking of using a t3/t4 turbo because it comes with the turbo kit. The specs are this:


Compressor Specs :
3" Compressor Inlet
3.000" or 76.20mm Major
1.988" or 50.50mm Minor
Compressor .50 A.R.
Compressor 57 Trim
M24 / T4 Compressor Housing

Turbine Specs :
T3 Type Turbine
11 Blade Type
2.25" Exducer
Turbine .64 A.R.
Turbine 76 Trim
2.560 " or 65.04mm Major
2.204 " or 56.00mm Minor
Exhaust Outlet Flange with 5 bolt design

How many psi do you have on your turbo?
Thank you so much again for taking the time to answer me!

Tune is 8-12 psi. It should work fairly well with that turbo. But please have a wideband hooked up to know what AFR your getting. I used 2-3 d16 calibrations before i went to the dyno and the last calibration i thought was on point bu the tuner said I was detonating a little bit with that tune. If i get some time tomorrow I'll post it up for you

I didnt forget about you bud. I tried pulling the tune from the ECU but apparently you can corrupt the calibration doing this. I'm gonna have to email my tuner and see if he kept my tune on file and if he can email it to me.

alston3ptswish wrote:I didnt forget about you bud. I tried pulling the tune from the ECU but apparently you can corrupt the calibration doing this. I'm gonna have to email my tuner and see if he kept my tune on file and if he can email it to me.

Great!! I will wait for you, thank you so much!!!

where is the calibration? bump

zombie247 wrote:where is the calibration? bump

Still no news. I'll let you know if he contact me by pm!