Page 1 of 1
Tuning on an s300 v1 then moving the cal to an s300 v2
Posted: Thu Mar 21, 2013 11:00 am
by 7rrivera7
If the version of Smanager stays the same, will a calibration created on V1 hardware work on v2 hardware without changes? I was asked this by a client waiting for his v2 board but in the need to tune his car today on v1 hardware and does not want to lose his investment in tuning/dyno time.
Re: Tuning on an s300 v1 then moving the cal to an s300 v2
Posted: Thu Mar 21, 2013 11:29 am
by Spunkster
Yes, you will have to reupload the calibration once the new s300 arrives.
Re: Tuning on an s300 v1 then moving the cal to an s300 v2
Posted: Thu Mar 21, 2013 11:34 am
by 7rrivera7
Excellent - thank you. Just to validate, a V1 hardware tune will run exactly the same on V2 hardware.
Re: Tuning on an s300 v1 then moving the cal to an s300 v2
Posted: Thu Mar 21, 2013 12:08 pm
by Spunkster
yes