Hondata

Hello i need a s300 d16y8 basemap does anyone can help me please? it´s an european civic.



thanks

can anibody help me? i realy need a basemap can i use a d16z6?

no one?

why put s300 on a stock y8?

keto06 wrote:why put s300 on a stock y8?

hello

because it´s intalled in a civic eg4 obd1 can i put the original ecu on it?

I Can put a p2p with a Wiring conversion in europe the d16y8 dont have the second o2 sensor my problem is the knock sensor i think

The Hondata thred is mine :(

Do not change mecanical timming.

I had to widen the holes in the dizzy so i could clock it more towards the firewall. Then you manage to time it to 12' degree.

Use the d16z6 base map and you are ok.

The y8 head likes a few degree less timing so you could altert the map slightly.

Have'nt had my car on the dyno yet :(

Going to do it within the nex couple of months, but now the motor is fully built :( so no valid data for a stock y8.

Ok so you put the d16z6 map and set the timing on the map to 12? is that it and then you tune from there? i´m confused because i think the european cars are slight diferent than the american cars.


thanks

Use the z6 map.
Set timming in hondata to 12
And turn dizzy until it lines up with the middel line on the crank when useing a timminglight.

My car is from germany, but every y8 is made in the USA.

Btw i'm from norway

Thanks You are helping me a lot Can You show me a Photo in what line should it be line up?

Middel line of the 3 on the crank gear.

Look in any car manual to see it :)

Ok Thanks :-) im gonna make the swapp now :-)