NEED help with wideband analog input, all i see in volts
Posted: Thu Mar 14, 2013 5:14 pm
hello
yesterday i connected the white wire on my aem WB to the S300 analog input connection on the S300 board, so i could view/datalog afrs,
then i went to the smanager analog inputs and in the convertion table i choose aem 30-4100. changes the units to AFR, uploaded the cal started the car and all i can see is volts, not actual AFR's
how can i fix this?
thanks
yesterday i connected the white wire on my aem WB to the S300 analog input connection on the S300 board, so i could view/datalog afrs,
then i went to the smanager analog inputs and in the convertion table i choose aem 30-4100. changes the units to AFR, uploaded the cal started the car and all i can see is volts, not actual AFR's
how can i fix this?
thanks