Page 1 of 1
is there a way to have extra rpm rows with hdata s300
Posted: Fri Mar 08, 2013 6:26 pm
by jose_guzman22
is there a way to have extra rpm rows with hdata s300 , i mean to add more rows to the table to reach 10500 rpm???
thanks in advance
Re: is there a way to have extra rpm rows with hdata s300
Posted: Fri Mar 08, 2013 10:04 pm
by Hondata
Right click and change the rpm values.
Re: is there a way to have extra rpm rows with hdata s300
Posted: Mon Mar 11, 2013 6:06 pm
by whiterabbit
I think what he is asking is if there is a way to add another row. As in add another row to the 20 row table to have a total of 21 rows ect. I was curious about this as well.
Re: is there a way to have extra rpm rows with hdata s300
Posted: Tue Mar 12, 2013 9:22 am
by Spunkster
No, you cannot add rows, but you can re-index the rows available.
http://www.hondata.com/help/smanager/ch ... tsub=index
Re: is there a way to have extra rpm rows with hdata s300
Posted: Tue Mar 12, 2013 1:31 pm
by whiterabbit
I know about re-indexing the rows. I was thinking there might be a way to add rows so that I could adjust the map at 100 rpm intervals all the way through the rpm range. Now that I think about it, I could use the secondary tables and have it always enabled and set the min engine speed to whatever the primary table leaves off at and continue the tune on the secondary tables. It would still be nice to be able to expand the tables though.