Page 1 of 1
full throttle shift help!!!!
Posted: Fri Jan 04, 2013 10:34 am
by vteckiller
hello
I would like to connect my switch but I have a problem ..
Connector I have the E22 ecu ok
but I'm going to switch the +12 V or ground???? thank you
my car civic type r ep3 europeenne
hondata kpro
Re: full throttle shift help!!!!
Posted: Fri Jan 04, 2013 11:28 am
by Spunkster
Brake switch input should be powered, but check with a multimeter to be sure before connecting it to the ECU.
Re: full throttle shift help!!!!
Posted: Fri Jan 04, 2013 1:16 pm
by vteckiller
thank you
+12 V switch on and switch to the ecu E22
sorry
why I measured with a multimeter??
Re: full throttle shift help!!!!
Posted: Fri Jan 04, 2013 1:50 pm
by Spunkster
To make sure you are not giving power to a ground input or ground to a powered input. This will help you prevent damaging the ECU or blowing fuses.
Re: full throttle shift help!!!!
Posted: Fri Jan 04, 2013 2:10 pm
by vteckiller
oki
thank you
Re: full throttle shift help!!!!
Posted: Sat Jan 05, 2013 2:32 pm
by vteckiller
hello if I use my E16 ecu pin.
switch must be connected to ground???
thank you
Re: full throttle shift help!!!!
Posted: Sat Jan 05, 2013 2:36 pm
by vteckiller
what is the best solution E16 or E22???
Re: full throttle shift help!!!!
Posted: Sat Jan 05, 2013 7:18 pm
by 05typeR
E29 seems to be the simplest in my opinion and the connection is right by the driver's clutch pedal, kinda.
Just needs a ground.
Re: full throttle shift help!!!!
Posted: Sun Jan 06, 2013 4:06 am
by vteckiller
thank you to you for your help..
my car is european driver is left.
205 connector is on the left of the clutch pedal??
thank you
Re: full throttle shift help!!!!
Posted: Sun Jan 06, 2013 4:14 am
by 05typeR
My car is also a EDM but it's right hand drive, LHD is similar with same connections, it will be by the driver's accel pedal.
Re: full throttle shift help!!!!
Posted: Sun Jan 06, 2013 9:03 am
by vteckiller
thank you for your tips