Page 1 of 1
tuning Vss
Posted: Fri Dec 14, 2012 8:16 am
by rev_rage
when I installed larger wheels the Vss speed displays different then the actual speed of the car. Is there a way to tune this out on the Vss(mph) guage properties in the s300
Re: tuning Vss
Posted: Fri Dec 14, 2012 8:27 am
by Hondata
Parameters -> Misc -> ECU Speed -> Speed Sensor Correction
Re: tuning Vss
Posted: Fri Dec 14, 2012 11:20 pm
by kerndog
Does this change what the gage cluster on the dash board reads?
Re: tuning Vss
Posted: Sat Dec 15, 2012 11:16 am
by Hondata
No, the dash gets its speed directly from the speed sensor and so cannot be changed by the ECU.
Re: tuning Vss
Posted: Fri Jan 04, 2013 12:45 am
by chrisbogart
Hondata wrote:No, the dash gets its speed directly from the speed sensor and so cannot be changed by the ECU.
Is there a way to edit this vss % and splice into gauge cluster. i.e. changing type r cluster reading Km/hr to mp/h 1 Kilometer per Hour = 0.62 Mp/Hr.
Re: tuning Vss
Posted: Fri Jan 04, 2013 10:33 am
by Spunkster
No this is not possible from the ECU.
Re: tuning Vss
Posted: Sun Jan 06, 2013 2:40 pm
by SPOOLIN
so is this how you adjust the speed the data log shows in the graph verses the trap speed measured on the time slip? if so do i do a plus percentage to get it to match. i know when i cross the line its always been around 10 mph off or something like that.
Re: tuning Vss
Posted: Mon Jan 07, 2013 2:52 pm
by Spunkster
This is to adjust the speed calculated by the ECU for datalogging.