Hondata

How do i tie in the wideband signal wire to my s300 v2 i have the analog input harness but do i adjust anything in sensors?

Have you read the information in the help file?

http://www.hondata.com/help/smanager/an ... sub=analog

yes it has 14 to 1 listed on the analog sensor list but up at the air fuel list on o2 reading it does nothing i dont understand exactly what this means

You will only be able to datalog this as an analog sensor. You can create a new gauge on the display window to show the analog input and label it however you want.

Ok got it done i have a 94 INTEGRA LS pr4 ecu which wire do i cut and tie in the narrow band signal for the ecu o2 The LMX has both out puts

you can use both outputs.

you can wire the narrowband output to D14 and the wideband to D10.

i have hooked up my LM-2 to D14 via the tuner-harness. some say, that i won't get the whole reading, since D14 shall only read up to 3.8V, but seriously: who needs AF above 16?

best regards Lukas

I read that you have to modifie the board to use d10 th eeld for a wwide band reading? is that just because it only reads sooo much voltage?