Page 1 of 1
Display
Posted: Tue Oct 16, 2012 10:23 am
by Boyle.r
Is there a way to change MAP in display to show Kpa or Mbar rather than psi?
Re: Display
Posted: Tue Oct 16, 2012 10:28 am
by Spunkster
Yes change your units in settings, and in the sensor list.
Re: Display
Posted: Tue Oct 16, 2012 11:27 am
by Boyle.r
I have done that. It still shows Map(psi) in display?
Re: Display
Posted: Tue Oct 16, 2012 12:27 pm
by Spunkster
are the readings still in psi, or is it just labeled as psi. If it is just labeled PSI, then you can change the label by editing the display.
Re: Display
Posted: Tue Oct 16, 2012 12:28 pm
by Boyle.r
Spunkster wrote:are the readings still in psi, or is it just labeled as psi. If it is just labeled PSI, then you can change the label by editing the display.
I haven't done any datalogging yet. I'll try it later and see. Thanks for the help.