Page 1 of 1
S300 Upload Problem
Posted: Sun Sep 30, 2012 3:12 pm
by logan
I was able to upload cals yesterday, but I am know getting an SManager error: "Upload failed - please try uploading again." I have checked and re-socketed the S300, but still unable to upload. Can anyone help?
Re: S300 Upload Problem
Posted: Sun Sep 30, 2012 9:19 pm
by ncjmj
If it's an S300 V2 you have to be connected to the Internet to upload new cals
Re: S300 Upload Problem
Posted: Mon Oct 01, 2012 8:57 am
by Hondata
Not quite. You need to register the s300 (once) over the internet, but after that you do not need to be connected.
Re: S300 Upload Problem
Posted: Mon Oct 01, 2012 12:00 pm
by logan
Yes I had registered it over the internet, then with the internet connected it still could not upload.when I try to upload the ecu flashes red when I try to upload. I can download off the ecu to smanager but can't upload from smanager to the s300.
Re: S300 Upload Problem
Posted: Mon Oct 01, 2012 12:53 pm
by Spunkster
What is the serial number on the s300 board inside the ECU? From Help, About, what version of software are you using?
Re: S300 Upload Problem
Posted: Mon Oct 01, 2012 1:14 pm
by logan
20960 version 1.2.
Re: S300 Upload Problem
Posted: Mon Oct 01, 2012 1:18 pm
by logan
Version 2.1.1
Re: S300 Upload Problem
Posted: Mon Oct 01, 2012 2:07 pm
by Spunkster
No need to post here and email. This will be handled via email.