Hondata

Posted: **Sat May 15, 2004 9:06 am**

My ecu will no longer allow me to upload or datalog. In addition it seems as if its in a fail safe mode with a rev limiter at 4,000 Rpm.

The green light is solid and the Red light is flashing until i try to datalog and or upload. When i try and datalog the red light goes solid and it does not datalog. The datalog record button goes gray for a sec or 2 and then goes back to red.

When i remove the USB cable the green and red lights go off.

Any information is greatly appreciated.

Thanks

Posted: **Sat May 15, 2004 10:47 pm**

Call us on Monday.

Posted: **Sun May 16, 2004 9:35 am**

Thanks.

Posted: **Sun Jul 11, 2004 11:02 pm**

i'll be calling too, i have the same problom. i think my last error code it threw was daughter board comunication error.

Posted: **Mon Jul 12, 2004 2:02 pm**

did you guys ever figure out what causes this problom?

Posted: **Sat Jul 24, 2004 12:27 am**

i like to know also

Hondata

Rev limiter at 4 Grand solid red and green lights?

Rev limiter at 4 Grand solid red and green lights?

K-Pro