Hondata

I have a question about fuel map and the duty cycle %.
How can you see the fuel map in duty cycle % ?
Or can you see the value from fuel map in the datalog ?

Because it's hard to see what value in fuel map has been modified vs the logs.
Sometime i'm not sure if i have already modified the fuel map to readjust vs my af-ratio from the log.
So i can't compare the duty % with my fuel map table.

thank you

You cannot see the fuel maps in duty cycle %.

Use the map tracing to see where it is reading when looking at your datalogs.

Spunkster wrote:You cannot see the fuel maps in duty cycle %.

Use the map tracing to see where it is reading when looking at your datalogs.

I"m using that very nice feature already. But since i'm doing that part time, if i'm looking the datalogs next week, i may have forgot if i already did some change to those particular fuel cell since i cannot compare the fuel map with the duty cycle % ?