S300 - Analogue 2 / B6 - 0-5v datalogg input
Posted: Sun Aug 12, 2012 8:43 pm
Gday Guys,
Currently own a Hondata S300. Currently setup my watermeth flow gauge (0-5v) to datalogg into my analogue 2 B6 input.
The Smanager states that resistors r1 & r3 need to be removed for this input to function correctly. However it does not
state if the circuit is to remain 'open' or if a jumper wire needs to be installed in the place of the resistors
thanks guys
Currently own a Hondata S300. Currently setup my watermeth flow gauge (0-5v) to datalogg into my analogue 2 B6 input.
The Smanager states that resistors r1 & r3 need to be removed for this input to function correctly. However it does not
state if the circuit is to remain 'open' or if a jumper wire needs to be installed in the place of the resistors
thanks guys